Page:Light waves and their uses.djvu/105

From Wikisource
Jump to navigation Jump to search
This page has been validated.
Light Waves as Standards of Length
87

between the point of suspension and the center of gravity of the spherical bob. This distance can be measured to a very fair degree of accuracy. Unfortunately the different observations vary among themselves by quantities even greater than the errors of the diffraction method.

The second of these proposed standards was the circumference of the earth measured along a meridian, as it was believed that this distance is probably invariable. There are, however, certain variations in the circumference of the earth, for we know that the earth must be gradually cooling and contracting. The change thus produced is probably exceedingly small, so that the errors in measuring this circumference would not be due so much to this cause as to others inherent to the method of measuring the distance itself. For suppose we determine the latitude of two places, one 45° north of the equator and one 45° south. The difference in latitude of these places can be determined with astronomical precision. The distance between the places is one-fourth of the entire circumference of the earth. This distance must be measured by a system of triangulation—a process which is enormously expensive and requires considerable time and labor; and it is found that the results of these measurements vary among themselves by a quantity even greater than do those reached with the pendulum. So that none of these three methods is capable of furnishing an absolute standard of length.

While it was intended that one meter should be the one forty-millionth of the earth's circumference, in consequence of these variations it was decided that the standard meter should be defined as the arbitrary distance between two lines ruled on a metal bar a little over a meter long, made of an alloy of platinum and irridium. It was made of these two substances principally on account of hardness and durability. In order to bring the metal as nearly as possible