Page:Collected Physical Papers.djvu/27

From Wikisource
Jump to navigation Jump to search
This page has been validated.
COLLECTED PHYSICAL PAPERS
7

U tube is taken and the two limbs filled with copper sulphate and sulphuric acid, respectively; the bent portion of the tube is plugged with asbestos to prevent rapid mixing of the two liquids. A sliding ebonite piece carries a rod of zinc and a rod of copper, which are plunged in the two electrolytes. The cell is shunted with a resistance of about 10 ohms and the current flowing through the shunt, and therefore the derived E. M. F. is varied by varying the resistance of the cell by raising or lowering the electrodes. When no current is required, the rods are raised out of the liquids. A cell thus constructed is ready for use at a moment's notice, and will work for several days. The receiving circuit does not respond to the incident radiation unless a suitable E. M. F. acts on the circuit. The above simple method of adjusting the proper E. M. F. will be found very simple and effective.

When the Polariser and the Analyser are properly constructed, and the two exactly crossed, no radiation can reach the sensitive surface, and the galvanometer will remain unaffected. The field is then said to be dark. Any slight rotation of either the Polariser or the Analyser partially restores the field, and the galvanometer spot of light then sweeps across the scale.

Method of Experiment

The spark gap of the Radiator is adjusted in a vertical line. The wires of the Polariser are horizontal, and the transmitted electric ray is plane-polarised, its plane of vibration being vertical. The Analyser is now adjusted in a crossed position; on producing a flash of radiation by a single break of the primary, there is no effect on the galvanometer. The crystal to be ex-