Ill. 255. Drawing the Threads
blotting-paper between the two edges, loosen the tension of the machine and stitch a quarter-inch seam through all the thicknesses. (Ill. 253.) When the seam is stitched, cut the paper close to the stitching and pull it out. The stitches between the two edges of the material all then look like illustration 254. The edge toward the hem is turned down and the hem is stitched by machine, close to the turning. The raw edge of the garment is turned in and stitched by machine.
 Ill. 256. Run the Needle Under Four or Five Threads
|
 Ill. 257. Take a Stitch in the Material and Through the Loop
|
 Ill. 258. Work Down the Opposite Side, Taking the Same Number of Stitches
|
DRAWN-WORK makes an exquisite trimming for lingerie frocks and blouses, and for dresses for children and young girls. It is also used on lingerie. Cotton voile is the best material to use for drawn-work because the threads pull easily. This material can be used for dresses, blouses and underwear. Batiste and handkerchief linen can also be used, but it is a bit more difficult to draw the threads.
For household linens, drawn-work adds to the beauty and value of the linen and can be used alone or with hand-embioidery.
 Ills. 259 and 260. For Twisted-Thread Drawn-work |
|
Drawn-work can only be done on the straight line of the goods, for it is done with the drawn threads. It can never be done on a circle or curve.
Ills. 262. and 263. Twisted-Thread Drawn-Work
To prepare to draw the threads decide on the length of the drawn-work. Measure up the required number of inches and place a mark. Draw one thread from this mark, then with the points of a sharp pair of scissors cut across the desired number of threads. (Ill. 255.) Pull out a little of each thread with a pin and pull the thread. On voile two or three can be drawn at a time.
When the threads are drawn, run the needle under four or five threads (Ill. 256), using number sixty cotton for the blouses and number sixteen twisted
