rately, but easily, to the corresponding part of the lower curb. The disc is not fastened to the lower curb, but is retained in its place, horizontally, by the latter.
27. M M, the disc pipe. The disc is fastened to the bottom of the disc pipe by fifteen tap screws, one and a quarter inches in diameter. As there is a vertical pressure on the disc, due to the pressure of the whole head, on its horizontal area, the disc pipe and its fastenings require to be very strong. The pipe is eight and a half inches diameter, inside, or one and a half inches larger than the shaft passing through it, and is one and a quarter inches thick. The upper flange is furnished with adjusting screws, by which the weight is supported upon the upper curb, and which afford the means of adjusting the height of the disc. The escape of water between the upper curb and the upper flange of the disc pipe, is prevented by a band of leather on the outside, which is retained in its place by the wrought iron ring P. This ring is made in two segments. The top of the disc pipe, just below the upper flange, has two projections, or wings, which fit into corresponding recesses in the top of the curb; these are to prevent the disc from rotating in the opposite direction to the wheel, to which there is a powerful tendency, arising from the reaction of the water issuing from the guides.
28. R R, the regulating gate. This is represented on the section, at plate I., as fully raised, and in this position the wheel would be giving its full power. The gate is of cast-iron, the cylindrical part is one inch thick, the upper part of the cylinder is stiffened by a rib, to which are attached three brackets, one of which is shown at S, plate I., and the two others at S S, plate II. To these brackets are attached wrought iron rods, by which the gate is raised and lowered. The brackets are attached to the gate at equal distances, and therefore the rods support equal parts of its weight. To one of the rods is attached the rack V. The other two rods are attached, by means of links, to the levers T T, plate II. The other ends of these levers carry geared arch heads, into which, and into the rack V, work three pinions, W, of equal pitch and size, fastened to the same shaft. As the fulcrums of the levers T T, plate II., are exactly in the middle, between the pitch lines of the arch heads and the points to which the rods are attached, it will be seen, that by the revolution of the pinion shaft, the gate must be moved up or down, equally on all sides. The shaft on which the pinions are fastened, is driven by the worm wheel X, plates I. and II.; this is driven by the worm a, either by the governor Y, or the hand wheel Z. The shaft on which the worm a is fastened, is furnished with movable couplings, which, when the speed gate is at any intermediate points between its highest and lowest positions, are retained in place by spiral springs; in either of the extreme positions, the couplings are separated by means of a lever, moved by pins in the rack V; by this means both the
