The Woman and the Car
before removing the trembler blade, screw or plug. When the trembler blade and screw are replaced they will require readjustment. When you think they are set at the proper point, switch on, and give the starting-handle a few turns as if to start the engine, at the same time hold down the inlet valve, by pressing down the small button on top of cylinder. While turning, watch the spark between the two points. If it is feeble the adjustment is not correct, the screw is either tight or too loose. After a few attempts you will be able to adjust very quickly and almost unerringly.
See that the points are kept free from oil.
Loose terminals.—The car may run badly on account of a loose terminal of the wires on the sparking-plug or battery. This is simply a matter of thoroughly tightening up the various little nuts with a spanner. It is a good plan to just look over these occasionally, for when the terminals once begin to work loose they will gradually get worse and you will probably have a stop on the road.
Irregular petrol-supply.—If the carburetter
59
