of the said wheel, it would cause the dial B to make a complete revolution; but it is necessary that the dial B should only move through three divisions, and, therefore, when three divisions of this dial have passed under its index, the aforesaid bolt must be withdrawn: this is accomplished by a small wedge, which is placed in a fixed position on the wheel behind the dial B1, and that position is such that this wedge will press upon the bolt in such a manner, that at the moment when three divisions of the dial B have passed under the index, it shall withdraw the bolt from the teeth of the wheel which it drives. The bolt will continue to revolve during the remainder of the first quarter of a turn of the axis, but it will no longer drive the dial B, which will remain quiescent. Had the figure at the index of the dial B1 been any other, the wedge which withdraws the bolt would have assumed a different position, and would have withdrawn the bolt at a different time, but at a time always corresponding with the number under the index of the dial B1: thus, if 5 had been under the index of the dial B1, then the bolt would have been withdrawn from between the teeth of the wheel which it drives, when five divisions of the dial B had passed under the index, and so on. Behind each dial in the row D1 there is a similar bolt and a similar withdrawing wedge, and the action upon the dial above is transmitted and suspended in precisely the same manner. Like observations will be applicable to all the dials in the scheme here referred to, in reference to their adding actions upon those above them.
There is, however, a particular case which here merits notice: it is the case in which 0 is under the index of the dial from which the addition is to be transmitted upwards. As in that case nothing is to be added, a mechanical provision should be made to prevent the bolt from engaging in the teeth of the wheel which acts upon the dial above: the wedge which causes the bolt to be withdrawn, is thrown into such a position as to render it impossible that the bolt should be shot, or that it should enter between the teeth of the wheel, which in other cases it drives. But inasmuch as the usual means of shooting the bolt would still act, a strain would necessarily take place in the parts of the mechanism, owing to the bolt not yielding to the usual impulse. A small shoulder is therefore provided, which puts aside, in this case, the piece by which the bolt is usually struck, and allows the striking implement to pass without encountering the head of the bolt or any other obstruction. This mechanism is brought into play in the scheme, fig. 1, in the cases of all those dials in which 0 is under the index.
Such is a general description of the nature of the mechanism
