perpendicular to the bottom of the tray, but a little outwards above, and the proper degree of inclination is easily given by using a mould upon which to bend the corners. This should be a thick square piece of wood having the four corners cut with different degrees of obliquity: when the corners of the tray are first imperfectly formed, it will be easy to ascertain by trial,
 | An image should appear at this position in the text. To use the entire page scan as a placeholder, edit this page and replace "{{missing image}}" with "{{raw image|Experimental researches in chemistry and.djvu/267}}". Otherwise, if you are able to provide the image then please do so. For guidance, see Wikisource:Image guidelines and Help:Adding images. |  |
which corner of this mould will give the obliquity and position already described as necessary, after which the folding may be easily finished upon it. The accompanying sketch represents first a good and then a bad folding.
38. All occasion for changes in the folds, especially at the corners, should be avoided. The folds should be decided upon as the work proceeds, so advantageously as to make alterations unnecessary. The closer the corners are pressed, the smaller is the quantity of glass contained in them, and the less risk is there of the platinum being broken when the finished glass is taken out; but it is proper to avoid general contact between the corners and the sides against which they are disposed, otherwise welding is likely to occur during the stirring, and the platinum is injured for future experiments.
39. The tray being formed is again to be examined for holes, first by a light as before (31), and then in the following manner:—Being laid upon a sheet of bibulous paper, alcohol is to be carefully poured in until the fluid is within the fourth or the sixth of an inch of the lowest edge of the tray, so as to occasion no running over at the sides or corners. If a large hole exist, it will be rendered visible immediately; but if none such appear, a large basin or some other cover is to be placed over the tray to prevent evaporation, but without touching the vessel or its contents; and the whole is to remain undisturbed for some hours. Being then examined, the wetting of the paper will indicate a hole or a badly-folded corner, and will point out the faulty place: the tray may easily be shifted from one part of the paper to another for the discovery of any moistened places beneath. Sometimes holes occur so small that alcohol will not run in a sensible quantity through them. Suspected places of this kind and suspicious corners also should
