Page:Light waves and their uses.djvu/38

From Wikisource
Jump to navigation Jump to search
This page has been validated.
20
Light Waves and Their Uses

This flame is produced by allowing a jet of gas to issue under considerable pressure from a small nozzle, and by gradually increasing the pressure until the flame is on the point of flaring. On blowing the whistle, we observe that the flame ducks; it is lowered to perhaps one-third or one-fourth of its height, and broadens out at the same time. On placing the whistle behind an obstacle, we observe by the ducking of the flame that it responds to the whistle almost as readily as when no obstacle was present.

I now take a shorter whistle, half an inch long; which, therefore, produces a sound wave two inches long. The flame responds even more readily to this than to the longer whistle, and when the shorter whistle is sounded behind the obstacle the flame ducks, but to a much less marked degree than before.

I have here the means of producing still higher sounds. Strung on a piece of wire are a number of iron washers—rings of iron about an inch in diameter. When these are shaken they produce vibrations whose wave length is even shorter than that produced by the whistle just sounded. On shaking the rings you perceive the immediate response of the flame, and on shaking the rings behind the obstacle the flame responds still, but much more feebly. I take a new set of rings one-half inch in diameter. On shaking these the flame responds as before, but when I place the rings behind the obstacle the flame scarcely responds at all. I take a still smaller series of discs. These are approximately only one-fourth of an inch in diameter and produce a wave whose length is approximately one-half inch. On shaking the last set of discs outside the obstacle the flame responds not quite so strongly as before, because the total amount of energy in this case is very small; but, on shaking the discs behind the obstacle, the flame is absolutely quiescent, showing that the sound shadow is perfect. In moving the discs