pigmentum powdered according to the quantity of Lead, about as much as will lye upon a half Crown piece will serve for eighteen or twenty pound weight of some sorts of Lead; others will require more, or less. After the Auripigmentum is put in, stir the Lead well, and the Auripigmentum will flame: when the flame is over, take out some of the Lead in a Ladle having a lip or notch in the brim for convenient pouring out of the Lead, and being well warmed amongst the melted Lead, and with a stick make some single drops of Lead trickle out of the Ladle into water in a Glass, which if they fall to be round and without tails, there is Auripigmentum enough put in, and the temper of the heat is right, otherwise put in more. Then lay two bars of Iron (or some more proper Iron-tool made on purpose) upon a Pail of water, and place upon them a round Plate of Copper, of the size and figure of an ordinary large Pewter or Silver Trencher, the hollow whereof is to be about three inches over, the bottom lower then the brims about half an inch, pierced with thirty, forty, or more small holes; the smaller the holes are, the smaller the shot will be; and the brim is to be thicker then the bottom, to conserve the heat the better.
The bottom of the Trencher being some four inches distant from the water in the Pail, lay upon it some burning Coles, to keep the Lead melted upon it. Then with the hot Ladle take Lead off the Pot where it stands melted, and pour it softly upon the burning Coles over the bottom of the Trencher, and it will immediately run through the holes into the water in small round drops. Thus pour on new Lead still as fast as it runs through the Trencher till all be done; blowing now and then the Coles with hand-Bellows, when the Lead in the Trencher cools so as to stop from running.
While one pours on the Lead, another must, with another Ladle, thrusted four or five inches under water in the Pail, catch from time to time some of the shot, as it drops down, to see the size of it, and whether there be any faults in it. The greatest care is to keep the Lead upon the Trencher in the right degree of heat; if it be too cool, it will not run through the Trencher, though it stand melted upon it; and this is to
