Page:Niosh tb guidelines.pdf/33

From Wikisource
Jump to navigation Jump to search
This page has been proofread, but needs to be validated.
IV.   Considerations in the Selection of Respirators
23

is essentially that which occurs at a mask's face seal. In marked contrast, with both surgical masks and NIOSH-certified, disposable, particulate-filter respirators (PRs), one must accept the likelihood of some hazardous leakage through the filter that adds to the hazardous leakage at the face seal.

E. Powered, HEPA-Filter Halfmask and Positive-Pressure, Air-Line, Halfmask Respirators—Available NIOSH-certified, powered, HEPA-filter respirators can supply a constant flow of HEPA-purified air under positive pressure for a period of 8 hours with a fully-charged battery pack. This type of filter respirator is also known by the general term powered, air-purifying respirator or PAPR. The specific type of PAPR discussed in these recommendations can be referred to as a "halfmask HEPA PAPR." Two examples of this respirator type are shown in Figures 1 and 2 on pages 34 and 35. NIOSH conservatively estimates that these respirators have less than 2% face-seal leakage under routine conditions (57).

The tight-fitting, elastomeric facepieces and breathing-hose assemblies of these respirators are small and relatively lightweight. The total weight of these devices can go to 5 to 6 pounds, most of which is in the belt-mounted battery, blower, and HEPA-filters assembly. These respirators are designed for continuous use in temperatures ranging from 40°F to 120°F.

The forced, HEPA-filtered airstream flowing into the facepiece of a powered HEPA-filter respirator offers the advantage of a cooling effect in conditions of warm temperatures (this can be a disadvantage for use in cold temperatures). More important, because minimal inhalation effort is needed by the wearer to draw air across the HEPA filters, breathing in a powered respirator is substantially more comfortable than in a non-powered filter respirator (e.g., NIOSH-certified, dust, fume, and mist (DFM) filter respirators).

In use against non-biological aerosols, HEPA filters are routinely replaced only when: (A) airborne materials load them to a point that the flow to the facepiece is not adequate to provide positive pressure or (B) physical damage occurs to a filter. However, in health-care