a potentiometer-slide arrangement. This is a matter of great importance, as I often found a receiver, otherwise in good condition, failing to respond when the E.M.F. varied slightly from the proper value. The receiver, when subjected to radiation, undergoes exhaustion. The sensibility can, however, be maintained fairly uniform by slightly varying the E.M.F. to keep pace with the fatigue produced.
The receiving circuit thus consists of a spiral-spring coherer, in series with a voltaic cell and a dead-beat galvanometer. The receiver is made by cutting a narrow groove in a rectangular piece of ebonite, and filling the groove with bits of coiled steel springs arranged side by side in a single layer. The spirals are prevented from falling by a glass slide in front. The spirals are placed between two pieces of brass, of which the upper one is sliding and the lower one fixed.
Fig. 3.—The Spiral Spring Receiver.
These two pieces are in connexion with two projecting metallic rods, which serve as electrodes. An electric current enters along the breadth of the top spiral and leaves by the lowest spiral, having to traverse the intermediate spirals along the numerous points of contact. The resistance of the receiving circuit is thus almost entirely concentrated at the sensitive contact-surface, there being little useless short-circuiting by the mass of the conducting layer. When electric radiation is absorbed by the sensitive surface, there is a sudden diminution of the resistance and the galvanometer spot is violently deflected.
By means of a very fine screw the upper sliding-piece can be gently pushed in or out. In this way the spirals may be very gradually compressed, and the resistance of the receiver diminished. The galvanometer spot can thus easily be brought to any convenient position on the scale. When
