^ryiilKll kjl^iciivo JiUU/llfll If
��4Y0
��The two jaw clip spacers, and one hinge clip spacer, are also made from bus bar copper. Cut them to length, file the edges, and bend up one end in a vise. Drill the jaw clip spacers as in detail 4 and the hinge clip spacer as in detail 6.
Get some sheet copper j'i in. thick, and
��draw an outline of the hinge clip upon it as shown in detail 3. Cut around it with a hack saw, finish it with a file, and drill it as indicated.
As shown in detail 7, cut ofT a piece of bus bar copper for the blade, 9}i in. long, and drill a 17/64-in. hole % in. from one
2'
��,-J 3 HOLES ^ DRILL
���TOP CUP 4 10-32 TAP . BOTTOM CUP 4 H0LE5 9 DRILL DPT 5 2 TOP & 2 BOTTOM REQD.
��DEI 5 i TOP A 1 BOTTOM REa'D
��DEI 4 Z REG'D
���I '— *r»
��i- y 4 DRILL
��L
��£i"
��^
��rr
��/
��>— ^ii^
��64 DRILL
��DRILL TO SUIT
HANDLE'
��/r
��fOKO
_i
��DET. 6
1 RtCiD DET. 7 1 REQD
Details of the parts that enter into the construction of a grounding, single throw switch in which their combination gives a maximum insulation efficiency at a minimum cost
��dJ
�� �