Page:The Golden Hamster Manual.djvu/21

From Wikisource
Jump to navigation Jump to search
This page has been validated.

19. Hobby Hamstery Pens

Simple stack-locking, gnaw-proofing, and self-cleaning features make these pens unusually popular with hobbyists, home laboratory and research workers, sportsmen, and other small producers. Pens are so light that even a frail person may easily handle them. Hobby Hamstery Pens are not observation pens or display sages, but breeding pens designed for high productivity. Wire doors provide sufficient vision for study of the animals and their habits. Each pen is standard size, 8×10×21 inches inside.

In all construction, it should be remembered that so-called 2-Inch boards may be only 1+58-inch thickness, and 1-inch boards 58- to 78-inch thickness, depending upon grade of lumber. A board selling as a 6-inch width may actually be 5+58 inches. So, a so- called 10-inch height inside a pen may be 38 less than 10 Inches. This fact is mentioned so that the builder will make doors to fit doorways after the rest of the pen is completed. Doors required may be slightly wider, but less tall, than otherwise might be expected. Saw boards to lengths shown in list of materials, and other details will work out nicely.

HOBBY PEN BUILDING MATERIALS

Dimensions are given in inches.

Key:

E,P
Three 1×10×22 boards, 2 ends and 1 partition.
1
Bk
One 1×10×19 back (Fig. II).
1
DS
One 1+12x1×19 door sill (Figs. I and III).
1
N
Two 1×8×13 nest boards (Fig. III).
1
S
Four 1×4×15 stack-lock strips. Use 3 in. if preferred.
1
DF
One 1+12x1×72 for making 2 door frames.
1
BS
Four base strips, approx. 34 wide and 14 to 12 thick, 19 long for stripping hdw. cl. to bottom (Fig. V).
1
TP
One top 1×23×19, made up of 2 or more 1-in. boards 19 long.
1
Tr
One home-made droppings tray, 18 wide, either 12 or 23 long, and 1 to 2 deep, as preferred.
1
GB
Two guard boards 2×8, approx. 12 thickness.
1
GBR
Four pieces heavy sheet metal (galv. or. tin) 1×1+34 in.
1
DC
Two pieces 11×13 hdw. cl. for door coverings.
1
V
Two 5×5 pieces hdw. cl. for ventilation opening covers (Fig. II).
1
H
Four 1-inch hinges.
1
Ho
Two small hooks and eye-screws.
1
Flr.
One 19×24 piece either No. 4 or No. 6 hdw. cl. for floor.
1
CS
Four strips of scrap hdw. cl. 3×10 or 4×10 for climbing strips on either side of partition, shown in Fig. III.
1
Small quantities of 1. to 2-in, nails; small pkg. of small finishing nails or 1-in. wire brads; small pkg. of No. 5 double pointed tacks.

Lumber or board materials used need not be new, but should be hard wood and reasonably sound, especially for partition board (P). Saw ends of boards squarely to avoid cracks in corners. If corner cracks do occur, they may be covered by wood strips approx. 1 in. squared nailed into corners as corner posts (c.p.

—19—