Traffic Signs Manual/Chapter 3/2008/16

From Wikisource
Jump to navigation Jump to search
16TRAM SIGNS

GENERAL

16.1 The general principles for signing and marking tramways, including the use of variants to diagram 976 (see para 14.49), are set out in HM Railway Inspectorate’s "Railway Safety Publication 2, Guidance on Tramways” published on the Office of Rail Regulation website. Early contact should be made with the Inspectorate to discuss requirements. The following paragraphs give more detailed guidance on the use of traffic signs for street—running tramways.

16.2 At a priority junction, where trams share the major road with other traffic, STOP or GIVE WAY signs for the minor road should be provided in accordance with section 3. Warning signs for tramway crossings are covered in section 21 of Chapter 4. Details of road markings for tramways can be found in section 18 of Chapter 5. Para 14.49 in this chapter deals with speed limit signs for trams.

SIGNS FOR TRAM-ONLY ROUTES


953.1 Route for use by tramcars only

May be used only in combination with diagram 953.2. The bus symbol shown in diagram 953 or the local bus symbol shown in diagram 958 may be added below the tramcar symbol


953.2 Plate for use with diagrams 953 and 953.1

May be used only in combination with diagram 953 or 953.1

16.3 Where an on-street tramway enters a tram gate (or tram-only road), a segregated on-street tram route or an off—street tram route, signs to diagram 953.1 in combination with the "Only" plate to diagram 953.2 are provided. A "no entry" sign to diagram 616 cannot be used instead of diagram 953.1, as there is no prescribed supplementary plate with the legend "Except trams".

16.4 A tram gate is similar to a bus-only street or bus gate described in paras 15.29 to 15.32. Buses may share a tram gate, in which case the sign to diagram 953.1 is varied to include the bus symbol (normally the local bus symbol) as shown on working drawing P 953.1 (see para 1.9). The sign must not be varied to include the cycle symbol or the legend "taxi". Although cycles and taxis may be permitted to use a bus gate, there are safety issues with a tram gate.

16.5 The sign to diagram 953.1 should normally be 750 mm in diameter with the supplementary plate having an x-height of 75 mm. The largest sign size of 900 mm is likely to be more appropriate where a tramway leaves the public highway to enter an off—street route or at other locations where greater emphasis is required to ensure that drivers follow the correct route through a complex junction. The smaller sizes might be appropriate where traffic speeds are low and where access to traffic is generally restricted (e.g. where a tramway crosses a pedestrian zone).

16.6 A segregated on-street tram route is similar to a bus lane except that physical separation is provided between the tramway and that part of the road used by other traffic. No other traffic should be allowed to use the tramway, although it may be crossed by pedestrians. Figure 16-1 shows an example of each end of a one-way road used by all traffic, including trams, with a contra—flow segregated tramway. Figure 16-2 shows an example of a tramway leaving the public highway to enter an off—street route.

16.7 In certain situations it might be appropriate to provide a "keep left" or "keep right" sign to diagram 610 to guide other traffic away from a route used exclusively by trams, whether on-street or off—street. Regulation 15(3) exempts trams from the requirement to comply with such a sign.

16.8 An advance direction sign may indicate a route for trams only, as shown in figures 16-1 and 16-2.

16.9 There are no prescribed signs for a bus lane that is used also by trams. Where such provision is required, an application for sign authorisation should be submitted to the Department (see para 2.1).

A second sign assembly to and 953.2 diagrams 953.1 and 953.2 should be provided on the central island where this can be accommodated on a separate post from the sign to diagram 616 only

This sign requires authorisation by the Department as the legend "All traffic" only is not prescribed (see para 2.1)

The traffic signals should include a green arrow traffic indicating the only permitted movement for traffic (other than trams), together with a sign to diagram 606 (see paras 4.11 and 4.12)

The two layouts show the opposite ends of a one—way road with a contra—flow tramway

Figure 16-1 Example of a one—way road used by all traffic with a segregated contra—flow tramway

Figure 16-2 Example of a tramway leading from a public highway to an off—street route

PEDESTRIAN SIGNS 16.10 The sign shown in diagram 963.3 warns pedestrians of the presence of a tramway. The legend below the tram symbol may be varied to LOOK LEFT or LOOK RIGHT. These variants would be appropriate where trams travelling in opposite directions are separated by a pedestrian refuge or where the tramway is one way. Signs should be sited where the majority of pedestrians cross a tram route.


963.3 Tramway with traffic proceeding in both directions
(Sign for pedestrians)

"BOTH WAYS" may be varied to "LEFT" or "RIGHT"

16.11 Two sizes are prescribed for the sign to diagram 963.3. The larger size, with a 50 mm x—height, should normally be used. The smaller sign, with a 40 mm x—height, may be more suitable where there are space constraints, such as on a pedestrian refuge.

This work has been mirrored or sourced from material provided on the UK Government website at https://www.gov.uk/government/publications/traffic-signs-manual, which states material is available under the terms of the Open Government License unless indicated otherwise. (Crown copyright acknowledged.)


This is NOT an official transcription, and should NOT be considered in any way a controlled copy of the work in question.

This document no longer necessarily represents current practice, as it relates to an earlier version of the regulations (TSGRD 2002 as amended at publication date) rather than the current TSRGD 2016 regulations. It should not be used for actual design or operational use without consulting a more recent edition.


This version was transcribed in May 2015, from a 2008 impression.

This work is licensed under the Open Government Licence v3.0 (OGL v.3).

You are free to:
  • copy, publish, distribute and transmit the Information;
  • adapt the Information;
  • exploit the Information commercially and non-commercially for example, by combining it with other Information, or by including it in your own product or application.
You must, where you do any of the above:
  • acknowledge the source of the Information in your product or application by including or linking to any attribution statement specified by the Information Provider(s) and, where possible, provide a link to this licence;
  • If the Information Provider does not provide a specific attribution statement, you must use the following:
Contains public sector information licensed under the Open Government Licence v3.0.

Note: Since 2010, almost all information owned by the UK Crown is offered for use and re-use under the Open Government Licence by authority of The Controller of His Majesty's Stationery Office.info

See also: Meta for information on usage on Wikimedia wikis.

Public domainPublic domainfalsefalse