ing coat should cover the entire surface and should be mixed with raw oil and sufficient dryer to set the paint.
Brush out well between the slats. Never use paint of heavy consistency on blinds.
When drying, open the slats. Care must be taken never to allow the slats to turn down flat when drying, otherwise they will stick.
Veranda Columns and Rails. These should be primed as soon as set, as they are usually made of heavy lumber and liable to crack if not primed. Do not paint columns and rails unless dry. Paint will soon blister or peel on heavy timber if the least dampness is present. Do not paint over shop or mill priming without thoroughly sandpapering or scraping off as much of this paint as possible, as it is usually a cheap mixture applied heavy, preventing penetration and not fit for priming. It will generally peel in a short time after another paint has been applied over it. Do not be responsible for paint applied over primers other than the ones you applied. Do not apply paint heavy on round columns, as very little paint is required on a round or convexed surface. If applied heavy, it will soon blister, crinkle or peel. Carefully guard against an excess of paint on this kind of a surface. Use very nearly a dry brush and work the paint out well. The same applies to spindles and other turned work. Guard against painting the tops of rails and like surfaces which are damp from frosts or dews.
The Paint. The paint for veranda columns and rails should be reduced in the same manner as for the siding, but requires an extra amount of brushing. The paint should be well brushed out to insure smooth, even coats. Knife putty into all cracks and nail holes, using a good, hard-drying putty. Sandpaper the columns and rails before applying the finishing coat, dust off and apply a well brushed coat. This work, together with veranda and porch floors, should be the last finished on the exterior of the
